Connecting the camera to a computer and a printer
6
132
EN
Direct printing (PictBridge)
By connecting the camera to a PictBridge-compatible printer with the USB cable, you
can print out recorded pictures directly.
1
Connect the camera to the printer using the supplied USB cable and turn the
camera on.
Micro-USB connector
Smaller terminal
USB cable USB port
• Use a fully charged battery for printing.
• When the camera is turned on, a dialog should be displayed in the monitor prompting
you to choose a host. If it is not, select [Auto] for [USB Mode] (P. 115) in the camera
custom menus.
2
Use FG to select [Print].
• [One Moment] will be displayed, followed by a print-
mode selection dialog.
• If the screen is not displayed after a few minutes,
disconnect the USB cable and start again from Step 1.
Storage
Exit
Print
MTP
Proceed to “Custom printing” (P. 133)
• RAW images and movies cannot be printed.
To Next Page
Loading...
