Olympus E-M10 Mark III S - Adjusting Flash Output (Flash Intensity Control); Reducing Camera Shake (Image Stabilizer); FHD 60 P

Shooting
2
80 EN
Adjusting ash output (Flash intensity control)
Flash output can be adjusted if you nd that your subject to appears overexposed, or is
underexposed even though the exposure in the rest of the frame is just right.
1
Press the u button in P/A/S/M modes.
• In B, ART, SCN, and Z modes, the display of the
LV super control panel is controlled via [KControl
Settings] (P. 115).
2
Use FGHI to select [x], then press the Q
button.
3
Use HI to choose a value and press the Q
button.
250250 F5.6
P
1023
1:02:03
sRGB
Natural
S - AF
N
FHD
60p
S
Normal
WB
Auto
ISO
Auto
M-IS
S-IS On
± 0
A ± 0
± 0.0
±
0 ± 0
± 0
G ± 0
Flash intensity control
• This setting has no e󰀨ect when the ash control mode for the external ash unit is set to
MANUAL.
• Changes to ash intensity made with the external ash unit are added to those made with
the camera.
Reducing camera shake (Image Stabilizer)
You can reduce the amount of camera shake that can occur when shooting in low light
situations or shooting with high magnication.
The image stabilizer starts when you press the shutter button halfway.
1
Press the u button in P/A/S/M modes.
• In B, ART, SCN, and Z modes, the display of the
LV super control panel is controlled via [KControl
Settings] (P. 115).
2
Use FGHI to select [KImage Stabilizer] or
[nImage Stabilizer], then press the Q button.
3
Highlight an option using HI and press the Q
button.
250250 F5.6
P
1023
1:02:03
sRGB
Natural
S - AF
N
FHD
60p
S
Normal
WB
Auto
ISO
Auto
M-IS
S-IS On
±
0
A
±
0
± 0.0
±
0
±
0
±
0
G
±
0
K
Image Stabilizer
nImage
Stabilizer
KImage
Stabilizer
Still picture
(S-IS)
S-IS O󰀨 Image stabilizer is o󰀨.
S-IS On
The camera detects the panning direction and applies the
appropriate image stabilization.
Movie
(M-IS)
M-IS O󰀨 Image stabilizer is o󰀨.
M-IS
The camera uses both sensor shift (VCM) and electronic
correction.
M-IS
The camera uses sensor shift (VCM) correction only.
Electronic correction is not used.
• The image stabilizer cannot correct excessive camera shake or camera shake that occurs
when the shutter speed is set to the slowest speed. In these cases, it is recommended
that you use a tripod.
• When using a tripod, set [KImage Stabilizer]/[nImage Stabilizer] to [S-IS O󰀨]/[M-IS O󰀨].
• When using a lens with an image stabilization function switch, priority is given to the lens
side setting.
• You may notice an operating sound or vibration when the image stabilizer is activated.