Olympus E-M10 Mark III S - Wireless remote control flash photography

Cautions
7
142 EN
Wireless remote control ash photography (# RC Mode)
You can take wireless ash photographs using the built-in ash and a special ash with
a remote control function. The camera can separately control each of three groups of
remote ash units, and the internal ash. See the instruction manuals provided with the
external ash units for details.
1
Set the remote ash units to RC mode and place them as desired.
• Turn the external ash units on, press the MODE button, and select RC mode.
• Select a channel and group for each external ash unit.
2
Select [On] for [# RC Mode] in X Shooting Menu 2.
• Press the Q button to exit to the RC mode display.
Press the INFO button to cycle between LV super
controls or live controls and the RC mode display.
• Select a ash mode (note that red-eye reduction is not
available in RC mode).
• q is displayed on the monitor.
2
1
Shooting Menu 2
AF Illuminator
K
Elec. Zoom Speed
Normal
On
S-IS On
±0.0
K
Image Stabilizer
Intrvl. Sh./Time Lapse
Off
Back Set
#RC Mode Off
SilentsSettings
2
3
Adjust the settings for each group in the RC mode display.
250
A Mode
TTL
Manual
Off
+5.0
TTL +3.0
1/8
–
Low
1
Ch
1023
F5.6250
P
1:02:03
Flash intensity value
Group
• Select the ash control
mode and adjust the ash
intensity separately for
each group. For MANUAL,
select the ash intensity.
Normal ash/Super FP ash
• Switch between normal
ash and Super FP ash.
Communication light level
• Set the communication
light level to [HI], [MID],
or [LO].
Channel
• Set the communication
channel to the same
channel used on the ash.
Flash intensityFlash control
mode
Adjust settings for the
camera ash unit.
4
Rotate the ON/OFF lever to #UP to raise the ash.
• After conrming that the ash has charged, take a test shot.