30
3.3 Installation of equipment
CLV-190 INSTRUCTION MANUAL
Ch.3
Installation on the mobile workstation (WM-NP2, WM-DP2,
WM-NP1, WM-WP1, or WM-DP1)
1 Place the mobile workstation on a level surface. Lock the caster brakes by pushing
them down as shown in Figure 3.1.
Figure 3.1
2 According to the combination of equipment, install the shelf of the mobile workstation
as described in the mobile workstation’s instruction manual.
3 For WM-NP2, WM-DP2
Peel the paper from the back of the four foot
holders of the light source. Place the foot
holders to the four corresponding positions on
the rear and attach them lightly.
Figure 3.2
Caster brakes
Push to lock. Push to release.
To Next Page
Loading...
