Olympus EVIS EXERA III - Installation in Another Location

32
3.3 Installation of equipment
CLV-190 INSTRUCTION MANUAL
Ch.3
 Installation in another location
1 Place the pattern sheet and the foot holders at the installation location. Peel the paper
from the bottom of the foot holders and lightly attach the foot holders to the sheet.
Figure 3.4
2 Place the light source on the pattern sheet and check that the feet fit into the foot
holders.
3 Remove the light source from the pattern sheet.
4 Remove the pattern sheet and attach the foot holders firmly.
5 Place the light source so that the feet of the light source fit into the foot holders.
Pattern sheet
Peel off
Foot holder