XYT Image Acquisition
*Before starting the following procedure,
make adjustments for XY imaging. (refer to
page 4-5.)
Setting Time Series
① Select “ON” in [Time] on [Series] Tool
Window.
② Set the interval to acquire the image in
[Interval] and [Cycle] on [Time Lapse].
Starting Acquisition
③ Select [Normal] tab in [Acquire] Tool
Window. Press the button to display
the dialog box, and select the folder to
save the images.
*The acquire images are saved
automatically. Serial number is added at the
end of file name like “***_0001” and
“***_0002”.
④ Press the button to start
acquiring the image.
Finishing Acquisition
⑦ Finishing acquisition, buttons
blink.
Press the button to complete
the image acquisition. If you want to
Additional images under the same
condition, enter the number of additional
acquisition and press the button.
After the image is acquired, press the
button.
If you attempt to set the shorter than the time
displayed in [Scan] in [Interval], “FreeRun”
appears. In this case, the interval to acquire
the image is the time displayed in [scan].
7
①
②
③
④
⑤
To Next Page
Loading...
Need help?
General
