Inspection Before Use
3
3.1 Setup of Connected Equipment
34
IMH-20, 10 “4.2 Recording setting
(User settings)”
“REMOTE1” “OEP-5” Select the model of printer to connect. Be sure
to set this item to “OEP-5” when using this
instrument.
“Layout” “1 image (1 × 1)”
“2 images (1 × 2)”
“4 images (2 × 2)”
Select the number of multi-pictures to be
printed. Select one of listed setup items. “8
images (4 × 2)” is not supported.
“Caption” “Print”
“Not print”
Select the information to be printed in the
margin of print sheet.
“4.3 Setting about recording
(System settings)”
“Setting the functions”
“Devices”
“REMOTE1” “OEP-5” Select the model of printer to connect. Be sure
to set this item to “OEP-5” when using this
instrument.
UCES-3 No setup required.
UCES-2 “5.14 Operating the system
installation screen”
“Video printer” “OEP-4” Select the model of printer to connect. The
settings required may vary depending on the
software version. For details, refer to the
instruction manual supplied with this
instrument.
Table 3.1
Connected
equipment
Instruction Manual
references
Setup Item Setup Note
To Next Page
Loading...
