Troubleshooting
7
7.1 Troubleshooting Guide
80
Warning messages
When a warning is required, only the warning message
is displayed, and the “ALARM” lamp on the front panel
will not light up. Take measures according to the
displayed message.
MECHA TROUBLE:
PROCESS nn
MECHA TROUBLE nn
PROCESS
Paper jam inside this instrument. Removed the jammed paper as
described in “4.3 In the Case of a
Paper Jam” in
“INSTRUCTIONS (BASIC).”
A trouble other than paper jam
occurred inside this instrument.
Turn this instrument OFF, then
ON again.
MECHA TROUBLE: SENSOR
nn
MECHA TROUBLE nn
SENSOR
Paper jam inside this instrument. Removed the jammed paper as
described in “4.3 In the Case of a
Paper Jam” in
“INSTRUCTIONS (BASIC).”
A trouble other than paper jam
occurred inside this instrument.
Turn this instrument OFF, then
ON again.
—
PLEASE POWER OFF
POWER ON AGAIN
A trouble occurred inside this
instrument.
Turn this instrument OFF, then
ON again after a while.
Message
Possible cause Solution
Monitor LCD panel
Message
Possible cause Solution
Monitor LCD panel
HIT ANY KEY. HIT ANY KEY The “REMOTE 2” terminal is
used in the “CAPTURE STOP”
mode (CAP-STOP).
Press any key to exit from the
“CAPTURE STOP” mode.
INPUT MISMATCH INPUT MISMATCH A video signal other than NTSC
or HDTV (1080/59.94i) signal is
input.
Input the NTSC or HDTV
(1080/59.94i) signal.
This instrument is set up
improperly.
Set it properly according to the
input video signal.
A signal other than video signal
is input.
Input the NTSC or HDTV
(1080/59.94i) signal.
NO INPUT NO INPUT No signal is input from the
connected video source
equipment.
Turn the connected equipment
ON.
Set the connected equipment so
that it outputs the video signal.
This instrument and connected
equipment are connected
improperly.
Connect them properly as
described in “Chapter 2
Installation and Connection” in
“INSTRUCTIONS (BASIC)” or
in “INSTRUCTIONS
(ADVANCED) on page 17.”
This instrument is set up
improperly.
Set it properly according to the
input video signal.
The video equipment connected
between this instrument and the
connected equipment is turned
OFF.
Turn the video equipment ON.
NO IMAGE NO IMAGE Printing is impossible because
no image is stored in the
memory page.
Store images as described in
“Chapter 4 Operation” in
“INSTRUCTIONS (BASIC)” or
in “INSTRUCTIONS
(ADVANCED) on page 37.”
To Next Page
Loading...
