PV6088-F4E017
Do not touch on the light source. Moreover, do not put the thing.
The light source (U-LH100L-3) becomes very hot while the lamp is on. Do
not touch on the light source. Moreover, do not put the thing. It may lead to
the burn and a fire.
Do not cover with the vinyl cover etc. until the light source gets cold.
The light source (U-LH100L-3) becomes very hot while the lamp is on. Do
not cover with the vinyl cover etc. until the light source gets cold. It may lead
to a fire.
Do not handle the device with wet hands.
If the user handles the device with wet hands, or plugs or unplugs the power
cord using wet hands, severe electric shock could result.
Operate the device with the specified power!
Input voltage of the Control Box is configured to 100–120 V or 220–240 V,
depending on the shipment destination. There is a nameplate indicating the
voltage setting on the back surface. Use this product within the voltage
range. Otherwise there is a risk of damage or fire. Make sure to contact our
service department when you move it into a place having a different voltage
range.
Ground the unit securely!
Connect the earth terminal of a three-terminal outlet to the ground for safety.
Imperfect grounding may cause electric shocks. Without grounding, the
intended electrical safety is not achieved.
Always use the supplied cables.
Always usee supplied cables. Using any cables other than those supplied
may cause malfunctions due to internal and/or external noise.
To Next Page
Loading...
