PV6088-F4E017
Always use the supplied power cord.
Employing any other cables than those supplied may cause failures due to
internal and/or external noises.
The supplied cables are not usable with any other devices.
When no power cord is attached to the product, refer to the “Precautions for
proper use of the power cord” to choose a proper power code for the unit.
Replacement of fuses
Before replacing a fuse, turn off the power and unplug the power cord so as
to avoid electric shocks.
Rating of the fuse: 250 V AC, 3.15 A
Type of the fuse: Time lag , High breaking capacity type
Size of the fuse: φ5.2 mm 20 mm
Replacement of the lamp
Use the specified lamp for replacement. Otherwise there is a risk of damage
or fire.
Compatible lamp: 12 V 100 W (7023 from PHILIPS)
Do not install the device in an unstable location.
If the device is installed on an unstable platform, an inclined floor, or a floor
lacking sufficient rigidity, the device could fall or collapse, which might cause
bodily injury to the user or others in the area. Prior to installation, thoroughly
check the rigidity and flatness of the place where the device is to be
installed.
Do not change the lamp outright after turning it off!
To change the lamp because it was burnt out, or for any other reason, wait
till after it has cooled down enough, because it is very hot immediately after
switched off.
Failure to conform to the following cautions may cause injury or
physical damage to peripheral devices.
To Next Page
Loading...
