25
5 DANEO Control
This chapter introduces you DANEO Control, each functional section, and instructions to operate the
application. Important topics are configuring the acquisition, recording, observing, and analyzing
recordings.
DANEO Control is divided into two major workspaces: Acquisition and Analysis. The following figure
shows the home screen.
Figure 17: DANEO Control home screen
Acquisition
Create a new or open an existing DANEO Acquisition file (.dac). Within the acquisition, the
measurement system is configured and recordings can be performed. When you open a .dac file that
contains devices in the measurement system, the application tries to reconnect automatically.
Only one file can be opened per instance of the application. You cannot open the same file on multiple
instances.
Analysis
Create a new or open an existing DANEO Analysis file (.dan). You can analyze recordings located on
reachable devices or on a local hard disk.
To Next Page
Loading...
Need help?
General
