Omicron MPD 800 User Manual

OMICRON 15
MPD 800 measurement system
CAUTION
Minor or moderate injury caused by voltage or current possible
If the ratings are violated, damage or loss of precision of the equipment might be the
consequence.
► Observe the maximum current and power ratings of the measurement inputs.
► Never connect a voltage source directly to the AC inputs.
► Never connect a current source directly to the PD inputs having the internal quadripole
deactivated.
► If the internal quadripole is activated, make sure to observe the current rating of the PD
input.
WARNING
Death or severe injury caused by high voltage or current possible
The MPD 800 acquisition unit is not intended to be used for measurements which are
connected directly to mains circuits (IEC61010-2-030). Measurements of mains voltages
require accessories with proper CAT rating (< 1000 V
AC
) or proper lightning/switching
impulse over-voltage rating (>1000 V
AC
). Insulation transformer are not recommended.
► Make sure to connect the MPD 800 acquisition unit to the test setup using appropriate
rated accessories because the MPD 800 acquisition unit is not able to handle power
frequency fault currents.

Omicron MPD 800 Specifications

General

Brand	Omicron
Model	MPD 800
Category	Test Equipment
Language	English