Omron 3G3RX - Navigation; Language Selection

RX Quick Start Guide 15
PROGRAMMING RX
3.2 Navigation
LCD digital operator has four display modes which can be changed from one to another by pressing the or key at Navi-
gation level. Moreover, there are 3 other models called Read mode, Write mode and Option mode. In any display mode, it moves
to Read mode or Write mode via key or key, and moves to Option mode after pressing , and at the same
time. It returns to display modes via key.
Each mode has its own layers, where contents and parameters settings cannot be changed at Navigation level. When pressing
key at Navigation level, a cursor will appear on below layer.
LCD Navigation levels
To move among the different Navigation levels press keys or .The outline of each mode is shown below.
Monitor Mode A
The "d" group inverter parameters and "F~U" group inverter parameter are displayed on
the same screen in this mode. The content of "d" group parameter is displayed with big
font characters.The function code such as "F001" and contents of "F~U" parameters are
displayed, without the function name.
Monitor Mode B (Monitor x 4)
In this mode, four "d" group inverter parameters can be displayed at the same screen. The
function codes of these parameters are not displayed.
Function Mode (setting)
In this mode, "F~U" group parameters can be displayed and set. Function code, function
name, parameter content and parameter range are shown.
"d" group inverter parameter cannot be set and displayed in this mode.
Trip Mode
Trip information and warning information are displayed in this mode. With inverter trip
or a warning happens, the trip screen will be displayed from any display modes. In
Option Mode, Read Mode and Write Mode, the LED or WARNING LED will light up.
Pressing at the same time the up and down key in function code or data display will
enable the single-digit edit mode that allows a faster navigation, refer to the manual for
more details.
3.3 Language selection
To change the language is necessary to enter in OPTION MODE pressing , and
keys at the same time. The cursor will appear in the first row of the Option Mode
menu. Use or key to move between the option Mode menu. To return to the nav-
igator layer, press the key.
Select the Language option and press the key. The cursor will appear in the Language
option value. Use the or key to select the value to set. Press the key to store
the new value.Press the key to cancel the new value.
In the same way than the language is possible to set the date for the real time clock or use
the read and write operation. For more details refer to RX or AX-OP05 user’s manuals