Omron CX-PROGRAMMER 5.0-FUNCTION BLOCK OPERATION User Manual

93
Instruction Support and Operand Restrictions Section 2-6
2-6-23 Network Instructions
Instruction Mnemonic Function
code
Symbol Operands Supported
variable
data types
AT
setting or
array
variable
required
(Required
word data
size
shown in
parenthe-
ses.)
NETWORK SEND SEND
@SEND
090 S: 1st source word UINT Yes (not
fixed)
D: 1st destination
word
UINT Specify
address at
remote
node with
AT setti n g .
C: 1st control word WORD Yes (5)
NETWORK RECEIVE RECV
@RECV
098 S: 1st source word UINT Specify
address at
remote
node with
AT setting.
D: 1st destination
word
UINT Yes (not
fixed)
C: 1st control word WORD Yes (5)
DELIVER COMMAND CMND
@CMND
490 S: 1st command
word
UINT Yes (not
fixed)
D: 1st response
word
UINT Yes (not
fixed)
C: 1st control word WORD Yes (6)
EXPLICIT MESSAGE
SEND
EXPLT 720 S: 1st word of send
message
WORD Yes (not
fixed)
D: 1st word of
received message
WORD Yes (not
fixed)
C: 1st control word LWORD Yes (4)
WORD
must be
used
when
array vari-
ables are
required.
EXPLICIT GET
ATT RI BUT E
EGATR 721 S: 1st word of send
message
ULINT Yes (4)
WORD
must be
used
when
array vari-
ables are
required.
D: 1st word of
received message
WORD Yes (not
fixed)
C: 1st control word
message
LWORD Yes (4)
SEND
S
D
C
RECV
S
D
C
CMND
S
D
C
EXPLT
S
D
C
EGATR
S
D
C

Omron CX-PROGRAMMER 5.0-FUNCTION BLOCK OPERATION Specifications

General

Brand	Omron
Model	CX-PROGRAMMER 5.0-FUNCTION BLOCK OPERATION
Category	Software
Language	English