Omron fh series User Manual

1 From the Startmenu on your PC, select All Programs - OMRON - FZ_FH Series - FH_FHV
Launcher.
The Launcher window appears.
2
Click the Remote Operation Tool button.
3 In the Version select the version of the measurement application of the sensor controller to be
controlled remotely.
4 Click the Run button.
Note that the Sensor Controller must be placed in a measurement capable state.
Precautions for Correct Use
Do not connect or disconnect the Remote Operation Tool during a measurement or the system
running.
5
In the dialog displayed in the Remote Operation Tool, select or directly input the IP address
and Line No. for the Sensor Controller to be connected.
Additional Information
Click Browse to check the IP addresses and Line numbers for connectable sensor controllers.
If the network address of an IP address were different from a remote operation PC, the remote
operation cannot be connected even if the PC is displayed in the list.
Additional Information
The list will not be displayed during the Sensor Controller launched. Wait a while and click
Refresh to refresh the list.
The Line No. selected here is one of the following based on the system's operation mode.
10 Advanced Usage
10 - 10
FH/FHV Series Vision System User’s Manual (Z365-E1)

Omron fh series Specifications

General

Type	Machine Vision System
Series	FH Series
Power Supply	24 VDC
Storage Temperature	-20 to 60°C
Humidity	35 to 85% RH (non-condensing)
Image Sensor	CMOS
Processing Speed	High-speed processing
Connectivity	Ethernet
I/O	Digital I/O
Operating System	Embedded OS
I/O Ports	Ethernet, USB