Omron fh series - Setting DateTime [DateTime Settings]

4-9
Setting Date/Time [Date/Time Set-
tings]
Confirm that the date and time on the built-in calendar are correct, and make corrections if they are
not.
The log data dates and times are set based on contents set here.
Precautions for Correct Use
For the FHV series, the date and time setting used for the measurement ID is reset to the initial
value each time it is activated. Therefore, you need to set the date and time again with a com-
munication command or this procedure every time the power is turned on.
For details of communication commands for each communication module, refer to Vision
System FH/FHV Series User's manual for Communications Settings (Cat. No. Z342).
Setting Date/Time
1 In the Main Window, select System settings - Other - Date-time setting from the Tool menu.
The Date-time setting dialog box is displayed.
2
Set the current date and time.
3 Click Apply.
Setting Date/Time with Remote Operation Tool
1 In the Main Window, select System settings - Other - Date-time setting from the Tool menu.
The setting screen on the Sensor Controller is displayed on the remote operation PC.
4 Setting the Controller
4 - 46
FH/FHV Series Vision System User’s Manual (Z365-E1)