Omron FQ2-S4 - Page 416

Controlling Operation and Outputting Data with TCP No-protocol Communications
414
FQ2-S4 User’s Manual
End Continuous Measurements
The command ends continuous measurements.
<Command Format>
<Response Format>
When the Command Is Processed Normally
When the Command Is Not Processed Normally
Set the data output to output measurement results.
If data output is not set, only the command response is output.
Setting the Data To Output Automatically after Measurements: p. 403
ASME CR UR E / E
Delimiter
CR M/E
Delimiter
or
CR OK
Delimiter
CR
Measurement
result
CR OK
CR
Delimiter
Measurement
result
Data returned
for the number
of continuous
measurements
made.
Note