Omron NX1P2 series User Manual

6 - 91
6 Troubleshooting
NX-series NX1P2 CPU Unit Hardware User’s Manual (W578)
6-2 Troubleshooting
6
6-2-4 Error Descriptions
Event name Variable Changed to TRUE with Forced Refreshing Event code 90080000 hex
Meaning Changing a variable to TRUE with forced refreshing was specified.
Source PLC Function Module Source details None Detection
timing
Commands from
user
Error attributes Level Information Recovery --- Log category Access
Effects User program Continues. Operation Operation is performed according to the forced refreshing
values.
System-defined
variables
Variable Data type Name
None --- ---
Cause and
correction
Assumed cause Correction Prevention
Changing a variable to TRUE with
forced refreshing was specified by the
user.
--- ---
Attached
information
None
Precautions/
Remarks
None
Event name Variable Changed to FALSE with Forced Refreshing Event code 90090000 hex
Meaning Changing a variable to FALSE with forced refreshing was specified.
Source PLC Function Module Source details None Detection
timing
Commands from
user
Error attributes Level Information Recovery --- Log category Access
Effects User program Continues. Operation Operation is performed according to the forced refreshing
values.
System-defined
variables
Variable Data type Name
None --- ---
Cause and
correction
Assumed cause Correction Prevention
Changing a variable to FALSE with
forced refreshing was specified by the
user.
--- ---
Attached
information
None
Precautions/
Remarks
None
Event name All Forced Refreshing Cleared Event code 900A0000 hex
Meaning Clearing all forced refreshing values was specified.
Source PLC Function Module Source details None Detection
timing
Commands from
user
Error attributes Level Information Recovery --- Log category Access
Effects User program Continues. Operation Forced refreshing values are all cleared and operation is
performed according to the user program.
System-defined
variables
Variable Data type Name
None --- ---
Cause and
correction
Assumed cause Correction Prevention
Clearing all forced refreshing values
was specified by the user.
--- ---
Attached
information
None
Precautions/
Remarks
None

Omron NX1P2 series Specifications

General

Model	NX1P2 Series
Manufacturer	Omron
Type	Controller
CPU Units	1
Program Capacity	5 MB
Data Memory Capacity	128 KB
Ethernet Ports	1
Serial Ports	1
Built-in EtherNet/IP Port	Yes
Built-in EtherCAT Port	Yes
Built-in USB Port	Yes
SD Memory Card Slot	Yes
USB Port	1
Power Supply Voltage	24 VDC
Programming Language	Ladder, Structured Text, Function Block Diagram
Communication Protocols	EtherNet/IP, EtherCAT, Serial (RS-232C)