Omron NX1P2 series User Manual

1 Introduction to NX-series Controllers
1 - 16
NX-series NX1P2 CPU Unit Hardware User’s Manual (W578)
3) Wiring I/O
• Wiring the built-in I/O
• Wiring I/O for NX Units
• Connecting an Option Board
5-4-9 Wiring the Built-in I/O
on page 5-58
Manuals for the specific NX
Units
5-4-10 Wiring the
NX1W-CIF01 Serial Commu-
nications Option Board on
page 5-62
5-4-12 Wiring the Analog I/O
Option Board on page 5-70
• Wiring I/O to EtherCAT slaves Operation manuals for the
EtherCAT slaves
5-4 Wiring on page 5-39
4) Connecting the
Computer That
Runs the Sysmac
Studio
• Connecting the built-in EtherNet/IP port Sysmac Studio Version 1
Operation Manual (Cat. No.
W504)
Step 5. Checking Operation and Starting Operation on the Actual System
Step Description Sysmac Studio
Operations
Reference
1) Online Connection to
Sysmac Studio and
Project Download
Turn ON the power supply to the Control-
ler and place the Sysmac Studio online.
Then, download the project.
*1
Perform this step before you create the
slave configuration or Unit configuration
from the mounted Units in step 2-1.
Controller 
Communications
Setup 
Controller 
Synchronization
NJ/NX-series CPU Unit Soft-
ware User’s Manual (Cat. No.
W501)
2) Clock Data Setting Set the clock data with the clock function
when the battery is installed.
Controller  Con-
troller Clock
NJ/NX-series CPU Unit Soft-
ware User’s Manual (Cat. No.
W501)
3) Operation Check on
Controller
1. Check the wiring by using forced
refreshing of real I/O from the I/O Map
or Watch Tab Page.
2. For motion control, use the MC Test
Run operations in PROGRAM mode
to check the wiring. Then check the
motor rotation directions for jogging,
travel distances for relative
positioning (e.g., for electronic gear
settings), and homing operation.
3. Change the Controller to RUN mode
and check the operation of the user
program.
--- NJ/NX-series CPU Unit Soft-
ware User’s Manual (Cat. No.
W501)
4) Actual Controller
Operation
Start actual operation. --- ---
*1. Use the Synchronize Menu of the Sysmac Studio to download the project.

Omron NX1P2 series Specifications

General

Model	NX1P2 Series
Manufacturer	Omron
Type	Controller
CPU Units	1
Program Capacity	5 MB
Data Memory Capacity	128 KB
Ethernet Ports	1
Serial Ports	1
Built-in EtherNet/IP Port	Yes
Built-in EtherCAT Port	Yes
Built-in USB Port	Yes
SD Memory Card Slot	Yes
USB Port	1
Power Supply Voltage	24 VDC
Programming Language	Ladder, Structured Text, Function Block Diagram
Communication Protocols	EtherNet/IP, EtherCAT, Serial (RS-232C)