Appendicies
A-152
G5 Series AC Servo Drives With Built-in EtherCAT Communications, Linear Motor Type
Event name Position Data Initialized Event code 98020000 hex
Meaning A Config operation was performed during EtherCAT communications.
Source EtherCAT Master Function Module Source details Slave Detection
timing
Continuously
Error attributes Level Minor fault Recovery Error reset (after
resetting slave
errors)
Log category System
Effects User program Continues. Operation Power drive circuit is OFF for relevant slave.
Indicators EtherNet/IP NET RUN EtherNet/IP NET ERR EtherNet/IP LINK/ACT
--- --- ---
System-defined
variables
Variable Data type Name
None --- ---
Cause and
correction
Assumed cause Remedy Prevention
A Config operation was performed
during EtherCAT communications.
This operation is performed for safety
and is not an error.
(A preventative measure is not
required because this is a safety
measure.)
Attached
information
None
Precautions/
Remarks
“27” is displayed on the Servo Drive front panel and F727 is given as the AlarmCode (4001 hex)
Event name Fan Warning Event code 08020000 hex
Meaning The fan stop state continued for 1 second.
Source EtherCAT Master Function Module Source details Slave Detection
timing
Continuously
Error attributes Level Observation Recovery --- Log category System
Effects User program Continues. Operation Not affected.
Indicators EtherNet/IP NET RUN EtherNet/IP NET ERR EtherNet/IP LINK/ACT
--- --- ---
System-defined
variables
Variable Data type Name
None --- ---
Cause and
correction
Assumed cause Remedy Prevention
There is foreign matter in the fan. If there is foreign matter in the fan,
remove it.
Do not use the fan in an area
surrounded by excessive foreign
matter. Also, do not allow foreign
objects to enter.
The Servo Drive failed. If the above cause is not the cause of
the problem, replace the Servo Drive.
None
Attached
information
None
Precautions/
Remarks
“A3” is displayed on the front panel of the Servo Drive.
To Next Page
Loading...
Need help?
General
