4. If the following condition is not satisfied in the frequency refer-
ence constant setting:
Set frequency reference (Nos. 13 to 17, 41 to 44) ≤ Maximum
frequency (No. 2)
For the details, refer to V/f Constant Setting on page 44.
2-5 Digital Operator Operation Example
The following shows an example of digital operator operation.
Operation Pattern
FWD jog
operation
Select
FWD. RUN
Change
setting value
Select
REV.
RUN
Freq. setting
Power
supply on
STOP
FWD. RUN
15 Hz
FWD. RUN
60 Hz
REV. 60 Hz
!
Section 2-5
To Next Page
Loading...
