Omron SYSMAC C Series - Page 152

Index
Control task, sequence, timing, and relationship 3-2
Conventional relay-based systems 1-1
Conveyor belt motor control 6-4, 6-8
Copying programs 5-10
COUNTER (CNT) instruction B-7
Counter
forced set, reset 5-7
how to change set value 5-8
monitoring during operation 5-8
monitoring during operation 5-8
number range B-8
upon power failure B-9
value range B-8
Counters and timers, assigning numbers 3-4
Counters, rapid check of values 5-9
Counting products 6-8
CPU
failure, E-6
function 1-2
C20
basic unit 1-2
capabilities, basic unit 1-2
capabilities, expanded unit 1-2
channel assignment A-10
compatibility with higher-level C-Series 1-2
components 1-2
conveyor belt, use with 6-5
counting products 6-8
detecting defective products 6-8
DIP switches 2-1
expanded unit 1-2
alarm lamp, use with 6-8
limit switch, use with 6-1
machinery, use with 6-6
main components 1-2
memory capacity 2-1
memory chips 1-2
motors, use with 6-5
peripherals A-1
photoelectric switch, use with 6-1, 6-8
power supply E-5
power supply 2-6
proximity switch, use with 6-5
pushbutton switch, use with 6-6
robot arm, use with 6-8
system expansion A-t
ultrasonic switch, use with 6-1
valve, use with 6-6
‘versions 1-2