124
Section 5 General Communications Subcommands
RFID System
Operation Manual
Section 5
Communications
ABORT (XZ)
If the ID Controller does not return a response due to a problem during host communications or during
communications with a Data Carrier, the ABORT command can be executed to restore the ID
Controller to the Command Wait Status.
No response will be returned to the ABORT command.
■ 1:1 Communications
The ID Controller requires about 100 ms before it can receive the next command after it receives the ABORT command.
■ 1:N Communications
The ID Controller requires about 100 ms before it can receive the next command after it receives the ABORT command.
Command code
XZ
2
2
*CR
Terminator
Command code
x
Z
2
2
*CR
Terminator
2
xx
FCS
3
Controller No.
x
@
x
To Next Page
Loading...
