Omron V600 Series User Manual

39
RFID System
Operation Manual
Section 2 Wiring
Section 2
Installation and Wiring
■
Checking Installation
Check that the driver is correctly installed.
1. Connect the ID Controller to the personal computer using the USB interface.
2. On the Start Menu, select Settings - Control Panel - System.
3. Select the Device Manager Button on the Hardware Tab Page.
4. Select Ports (COM & LPT), and confirm that OMRON RFID USB COM is displayed.
The driver is correctly installed if this port is displayed.
Communications with the ID Controller can be performed with the COM number displayed in parentheses after OMRON RFID
USB COM.

Omron V600 Series Specifications

General

Operating Frequency	13.56 MHz
Supported Standards	ISO 15693, ISO 18000-3
Read Range	Up to 70 mm (depending on tag and environment)
Power Supply	24 VDC ±10%
Operating Temperature	-10 to 55°C (with no icing or condensation)
Humidity	35% to 85% (non-condensing)
Communication Interface	RS-232C