Onkyo TX-SR3100

62
Setup
2. Speaker
 5. Dolby Enabled Speaker
Change the settings of Dolby Enabled Speakers.
• This setting can be selected when "Conguration" - "Height Speaker" is set to
"Dolby Speaker".
 Distance from the ceiling (Default Value: 6' 0"/1.80 m)
Set the distance between the Dolby Enabled Speaker and the ceiling. Select
between "0.1 ft/0.03 m" and "15.0 ft/4.50 m" (0.1 ft/0.03 m units).
• The unit of distance (ft/m) is displayed using the unit selected for the
"Distance" setting.
 AccuReex (Default Value: O󰀨)
You can enhance the reection e󰀨ect of Dolby Enabled Speakers from the
ceiling.
• The function is not e󰀨ective if the listening mode is Direct.
O󰀨 When this function is not used
On When this function is used
 6. Speaker Virtualizer
The Speaker Virtualizer function can be switched between On and O󰀨.
 Speaker Virtualizer (Default Value: On)
On Listening modes such as T-D that have virtual speaker e󰀨ects
can be selected.
O󰀨 Listening modes such as T-D that have virtual speaker e󰀨ects
cannot be selected.
 7. Speaker Combo
"Speaker Combo" is a function that optimizes the crossover value suitable for
Klipsch speakers.
Setting the Klipsch speaker model to be used with "Speaker Combo" updates
the content of "Speaker" - "Crossover" on the Setup menu, and the crossover is
set to the optimized value suitable for the speakers.
 Brand (Default Value: Other)
Select the brand of your speakers.
Klipsch When Klipsch speakers are used
Other When other than Klipsch speakers are used
Front (Default Value: Other)
Center (Default Value: Other)
Height (Default Value: Other)
Surround (Default Value: Other)
Subwoofer (Default Value: Other)
Select the model of your speakers.
Select "Other" if yours is not in the list.
"Series": Select the series of speaker.
"Model": Select the model of speaker.