75
Advanced Setup—Continued
If several Onkyo components are used in the same room,
the remote controller’s control codes may overlap with
those of another component. To differentiate the remote
controller’s control codes, you can change its ID to
another number.
Notes:
If you change the remote controller’s ID, be sure to set
the same ID on both the remote controller and AV
receiver (see “e. Remote ID” on page 74). The default ID
for both is 1.
Changing the Remote Controller’s ID
1
Press and hold down the [RECEIVER]
button, and then press the TV [INPUT]
button.
2
Use the number buttons to enter a remote
control ID.
You can enter 1, 2, or 3.
10
--/---
11 12
REMOTE MODE
HDD
RECEIVER
TAPE/AMP
DVD CD
ZONE2
SAT
TV
VCR
CABLE
MDCDR
+
-
T
V CH
T
V VOL
DIMMER
SLEEP
INPUT SELECTOR
32
MACRO
1
+
10 0
CLEAR
12
3
456
789
INPUT
I
ON STANDBY
T
V
CD
V1 V2 V3
MULTI CH
DVD
TUNER
V4
TAPE
1
1
Number
buttons
To Next Page
Loading...
