Onkyo TX-SR653E

77
Zone 2—Continued
To use Zone 2, you must make this setting. It enables the
speakers connected to the ZONE 2 SPEAKERS termi-
nals so that they produce sound when Zone 2 is used.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
Setting the Powered Zone 2
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [ ]/[ ]
buttons to select “0. Initial
Setup,” and then press [ENTER].
The Initial Setup menu appears.
10
--/---
11 12
REMOTE MODE
HDD RECEIVER
TAPE/AMP
DVD CD
ZONE2
SAT TV VCR CABLE
MDCDR
STEREO SURR
DIRECT
SUBTITLEAUDIO
ALLST
PLAY MODE
VIDEO OFF
REPEAT
RANDOMREC PLAYLIST
OPEN/CLOSE
CINE FLTR
T V VOL
ENTER
S
E
T
U
P
T
O
P
M
E
N
U
M
E
N
U
VOL
+
-
CH
DISPLAY
PREV
CH
DIMMER
SLEEP
MUTING
LISTENING MODE
INPUT SELECTOR
32
MACRO
1
+
10 0
CLEAR
789
DISC
ALBUM
TEST TONE CH SEL LEVEL LEVEL
L NIGHT
R
E
T
U
R
N
2, 3
2
1, 4
1
RECEIVER
ENTER
ENTER
3
Use the Up and Down [ ]/[ ]
buttons to select “g. Powered
Zone 2,” and use the Left and
Right [ ]/[ ] buttons to select:
Not Activated: Zone 2 SPEAKERS
terminals deactivated.
Activated: Zone 2 SPEAKERS termi-
nals activated.
When Zone 2 is activated and turned on
(see page 78), the speakers connected
to the ZONE 2 SPEAKERS terminals
output sound, but the speakers con-
nected to the SURROUND BACK
SPEAKERS terminals do not (when
Zone 2 is activated but not used, the
surround back speakers work as nor-
mal).
4
Press the [SETUP] button.
The setup menu closes.
ENTER