Driving and operating 195
3. Open the tailgate. Lift the rear
floor storage cover and remove
the charge cord.
4. Plug the charge cord into the
electrical outlet. Electrical
requirements 3 208.
Verify the charge cord status.
Charge cord 3 205.
Select the appropriate charge
level. See "Charge limit selection"
in Programmable charging
3 197.
5. Plug in the vehicle plug of the
charge cord into the charge port
on the vehicle. Verify that the
charging status indicator
illuminates on top of the
instrument panel and an audible
beep occurs. Charging status
3 204.
6. Once charging, the vehicle plug
will be locked to the charge port
and cannot be disconnected while
charging is active.
Stop charging
1. To stop charging, when inside the
vehicle, use the Stop button on
the Charging screen. See
"Temporary charge mode
override and cancel” in
Programmable charging 3 197.
Additionally, the stop charge
button on the radio remote control
may also be used. Press and hold
5 on the radio remote control.
This will also unlock the vehicle
plug.
2. Unplug the vehicle plug of the
charge cord from the vehicle.
3. Close the charge port door by
pressing firmly in the centre until it
engages.
4. Unplug the charge cord from the
electrical outlet.
5. Place the charge cord into the
storage compartment.
To Next Page
Loading...
