220 Vehicle care
Bulb replacement
Switch off the vehicle and switch off
the relevant switch or close the doors.
Only hold a new bulb at the base. Do
not touch the bulb glass with bare
hands.
Use only the same bulb type for
replacement.
Replace headlight bulbs from within
the engine compartment.
Bulb check
After a bulb replacement switch on
the vehicle, operate and check the
lights.
Halogen bulbs
9 Warning
Halogen bulbs have pressurised
gas inside and can burst if you
drop or scratch the bulb. You or
others could be injured. Be sure to
read and follow the instructions on
the bulb package.
Xenon headlights
9 Danger
Xenon headlights work under
extremely high electrical voltage.
Do not touch. Have bulbs replaced
by a workshop.
Bulbs for front turn signal and
corner lighting can be changed.
Sidelight/Daytime running lights are
designed as Light Emitting Diodes
(LEDs) and cannot be replaced.
Front turn signal lights
1. Tilt the wheel and remove screws
on the outside of the wheel liner.
2. Rotate the bulb holder
anticlockwise to disengage.
3. Remove the bulb assembly
anticlockwise and pull it straight
out.
4. Insert a new bulb assembly
straight into the lamp and rotate
clockwise.
5. Reinstall the wheel liner with
screws.
To Next Page
Loading...
