Vehicle care 219
● See the Owner's Manual for
further information.
● Explosive gas may be present in
the vicinity of the vehicle battery.
Post-crash label
The post-crash label is located in the
door frame 3 152.
Wiper blade replacement
1. Lift the wiper arm
2. Press button to disengage the
wiper blade and remove.
3. Lower wiper arm carefully.
Wiper blade on the rear window
1. Pull the cover until it disengages.
2. Slide the cover toward the wiper
blade tip to unhook it from the
blade assembly.
3. Remove the cover.
4. Lift the wiper arm.
5. Push the release lever (2) to
disengage the hook and push the
wiper arm (1) out of the blade
assembly (3).
6. Push the new blade assembly
securely on the wiper arm until the
release lever clicks into place.
7. After wiper blade replacement,
ensure that the cover hook slides
into the slot in the blade assembly.
8. Snap the cover down to secure.
Headlight aiming
Headlight aim has been preset and
should need no further adjustment.
When driving in countries where the
traffic drives on the opposite side of
the road, it is not necessary to adjust
the low beam.
If the vehicle is damaged in a crash,
the headlight aim may be affected. If
adjustment to the low beam is
necessary, seek the assistance of a
workshop.
To Next Page
Loading...
