Chapter 3
Configuring TD4
This chapter describes the steps to configure TD4 prior to using it on a regular basis.
3.1 Startup sequence
When turned on, TD4 displays an initialization screen during the boot sequence. The
initial boot cycle (after a factory reset) will show a setup wizard that brings out key
system settings to make it easy to configure your TD4 for use. Interacting with that
setup wizard screen (by closing it or tapping the Full Settings button) will prevent it
from appearing in future boot cycles. Once booted past the setup wizard screen, TD4
displays the home screen and then sequentially powers on and detects connected
drives and mounts any supported filesystems.
3.2 Configuring TD4
TD4 default settings are defined using sensible, best-practice values. There are many
options and settings you can configure and customize to your specific needs. Tap the
System Navigation Menu icon in the upper left corner of the user interface to
access the System Navigation Menu, which includes following items:
Home: Return to the home screen.
Settings: Access the System Settings screen.
Administration: Access the Administration setup screen.
Lock System: Lock the screen with a PIN to prevent access while unattended.
About: Access the About screen to view additional information such as the unit
serial number, firmware version/hash, copyright, and licensing information.
Firmware update and factory reset are also initiated from this screen.
3.2.1 Settings
Tap Settings to display the Settings screen.
ISTD230100-UGD-EN-1
User Guide
19
To Next Page
Loading...