Opticon OPR 2001 - Default Settings 2: Read Options, Trigger, Buzzer

Opticon
OPR 2001
Specifications Manual
32
Notes:
In the “Reading” column, “
” means “Enable reading” and “X” means “Disable reading.”
In the “Transmit code length” column, “
” means “Transmit code length” and “X” means
“Do not transmit code length.”
In the “Transmit CD” column, “
” means “Transmit check digit” and “X” means “Do not
transmit check digit.”
In the “Calculate CD” column, “
” means “Calculate check digit” and “X” means “Do not
calculate check digit.”
“— “ means “not supported.”
In the “Prefix” column, “—“ means “there is no prefix setting.”
10.3. Default Settings 2: Read Options, Trigger, Buzzer
Item Default Setting
Setting the number of characters Fixed length OFF all codes
Read mode Single read
Multiple read reset time 500 ms
Add-on wait mode 500 ms
Multiple column read Disable
Default option
([X0] setting)
Read 1 times, redundancy = 0 Redundancy
Other options
([X1 .. X3] setting)
([BS .. BW] setting)
Read n times, redundancy = n+1 for the following
symbologies and lengths:
● Code 11 with length <= 5
● Code 39 with length <= 5
● IATA,Industrial 2of5, Interleaved 2of5 with length <= 8
● Matrix 2of5 (& Chinese Post), Scode with length <= 8
● MSI/Plessey with length <= 4
● NW-7 (Codabar) with all lengths
Trigger switch Enable
Trigger repeat Disable
Auto trigger Disable
Read time 2 seconds (when trigger enabled)
Margin check Normal
Buzzer duration 50 ms
Buzzer tone Single tone (3 kHz)
Buzzer loudness Maximum
Buzzer transmission Before transmission
Startup buzzer Enable
Good read LED Indicator duration 200 ms