Opticon OPR 2001 - Trigger and Read Settings; Enable;Disable Auto Trigger; Auto Trigger Stand Detection Settings

Opticon
OPR 2001
Specifications Manual
40
16. Trigger and Read Settings
16.1.1. Enable/Disable Settings
Use the following settings to enable or disable the auto trigger. (Auto trigger is
disabled by default).
To enable auto trigger, scan “ZZ”, “+I” and “ZZ” in that order.
To disable auto trigger, scan “ZZ”, “+F” and “ZZ” in that order.
Functions Menu labels Menu codes
SET
_ZZ_
ZZ
Enable auto trigger
_+I_
+I
Disable auto trigger
_+F_
+F
END
_ZZ_
ZZ
Note: Please configure the following after enabling the auto trigger.
16.2. Auto Trigger Stand Detection Settings
16.2.1. Stand Only
Enable auto trigger only when the scanner is inserted into the stand.
Functions Menu labels Menu codes
SET
_ZZ_
ZZ
Enable auto trigger
_+I_
+I
Enable auto trigger stand detection
_*4_
*4
END
_ZZ_
ZZ
(If the scanner is removed from the stand, auto trigger is disabled and the scanner
should be triggered manually.)