Page
24
DX17VGB
4.3.8 Drilling
Insert and tighten the drill bit.
Clamp the workpiece.
Unlock the emergency-stop.
Close drill chuck protection.
Put the drill bit with the drilling lever onto the workpiece and set the workpiece zero.
Select tool selection "drill bit" (LED is lit).
Select material and drill bit diameter with the rotary knob and confirm with the Enter key.
Adjust the set point of the drilling depth. "Setting the drilling or thread depth“ on page 20
Push Start.
The spindle turns; the holes
are drilled.
If necessar
y, change the preset speed with the rotary knob.
Press Stop.
4.3.9 Screw Thread Drilling
Insert and tighten the screw tap.
Clamp the workpiece.
Unlock the emergency-stop.
Close drill chuck protection.
Put the screw tap with the drilling lever onto the workpiece and set the workpiece zero.
Select tool selection "drill bit" (LED is lit).
Select material and diameter of screw tap with the rotary knob and confirm with the Enter
key.
Adjust the set point of the thread depth. "Setting the drilling or thread depth“ on page
20
.
Push Start.
The spindle turns; the threads are drilled. If necessary, change the preset speed with the rotary
knob.
Press Stop.
The spindle begins to rotate as soon as the drilling lever is moved downwards.
Insert the screw tap in the workpiece; the screw tap is pulled into the workpiece. Move the spin-
dle in the same direction with the drilling lever, but do not use any tractive force on the threads.
After reaching the thread depth setting, the rotation direction reverses and the screw tap rotates
back out of the workpiece.
The spindle stops rotating in the upper position.
The spindle begins to roatate again as soon as the drilling lever is moved downwards.
4.3.10 Piece Counting Function
The quantity of drilling lever movements for drilling and screw thread drilling are counted
separately.
Resetting the piece counter, see "Basic Value Setting“ on page
20
To Next Page
Loading...
