Version 1.2.8 - 2020-08-03 13Translation of original operating manual
MT50 GB
MT50_GB_1.fm
1.9 Safety devices
Use the milling-machine only with properly functioning safety devices.
Stop the milling-machine immediately if there is a failure on the safety device or if it is not func-
tioning for any reason.
It is your responsibility!
If a safety device has been activated or has failed, the milling-machine must only be used if you
have removed the cause of the failure,
have verified that there is no danger resulting for the personnel or objects.
WARNING!
If you bypass, remove or deactivate a safety device in any other way, you are endanger-
ing yourself and other personnel working with the milling-machine. The possible conse-
quences are
• injuries due to components or parts of components flying off at high speed,
• contact with rotating parts,
• fatal electrocution,
• pulling-in of clothes.
The milling machine includes the following safety devices:
a lockable main switch,
an emergency-stop push button,
a separating protective device on the vertical spindle,
a milling table with T-slots to fix the workpiece or the clamping device.
a removable chip and splash guard on the milling table.
WARNING!
The separating protective equipment which is made available and delivered together
with the machine is designed to reduce the risk of workpieces or fractions of them which
being expelled, but not to remove them completely. Always work carefully and observe
the limit values of your chipping process.
INFORMATION
The table housing of the cross table included in the scope of delivery can be used as
chip and splash guard. When using the horizontal mode, the chip and splash guard must
be mounted.
To Next Page
Loading...
