Optimum Optimill MT 50 - Change Information Operating Manual

Version 1.2.8 - 2020-08-03 85Translation of original operating manual
MT50 GB
MT50_GB_7.fm
straining of the machine.
- Any defects arising by one's own fault due to faulty operations or if the operating manual
is disregarded.
- Inattentive or incorrect handling and use of improper equipment.
- Non-authorized modifications and repairs.
- Insufficient installation and safeguarding of the machine
- Disregarding the installation requirements and conditions of use.
- Atmospheric discharges, overvoltage and lightning strokes as well as chemical influ-
ences.
 The following items are as well not subject to the liability or warranty claims:
- Wearing parts and components which are subject to a standard wear as intended such
as e.g. V-belts, ball bearings, illuminants, filters, sealings, etc.
- Non reproducible software errors
 Any services which OPTIMUM GmbH or one of its agents performs in order to fulfill in the
frame of an additional guarantee are neither an acceptance of the defects nor an accept-
ance of its obligation to compensate. Such services do neither delay nor interrupt the war-
ranty period.
 Place of jurisdiction among traders is Bamberg.
 If one of the above mentioned agreements is totally or partially inefficient and/or null, it is
considered as agreed what is closest to the will of the warrantor and which remains in the
framework of the limits of liability and warranty which are predefined by this contract.
9.4 Change information operating manual
Chapter Short note new version number
4.3 Information, switching the machine ON 1.1.1
4 Using of chip and splash guard 1.1.2
EC declaration new standard 1.1.2
2 Larger milling table from serial number J201310356 1.2.0
EC declaration changed standard 1.2.1
Digital position display removed, is enclosed separately 1.2.1
4.15 Conversion to horizontal milling, turning 180° 1.2.2
CE EMC 2014/30/EU & LVD 2014/35/EU 1.2.3
parts updated spare parts drawings 1.2.4
parts updated spare parts drawings, Transmission gear vertical
milling
1.2.5
2 ; 3; parts updated spare parts drawings complete, foundation plan,
installation plan
1.2.6
Spare parts Milling table 1.2.7
3 Interdepartmental transport 1.2.8