Optimum Optimill MT 50 - Appendix; Copyright; Terminology and Glossary; Liability Claims for Defects; Warranty

Version 1.2.8 - 2020-08-0384 Translation of original operating manual
MT50
GB
MT50_GB_7.fm
9 Appendix
9.1 Copyright
This document is copyright. All derived rights are also reserved, especially those of translation,
re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar means and
recording in data processing systems, neither partial nor total.
Subject to technical changes without notice.
9.2 Terminology/Glossary
9.3 Liability claims for defects / warranty
Beside the legal liability claims for defects of the customer towards the seller the manufacturer
of the product, OPTIMUM GmbH, Robert-Pfleger-Straße 26, D-96103 Hallstadt, does not grant
any further warranties unless they are listed below or had been promised in the frame of a
individual contractual agreement.
 The processing of the liability claims or of the warranty is performed as chosen by OPTI-
MUM GmbH either directly or through one of its dealers.
Any defective products or components of such products will either be repaired or replaced
by components which are free from defects. The property of replaced products or compo-
nents passes on to OPTIMUM Maschinen Germany GmbH.
 The automatically generated original proof of purchase which shows the date of purchase,
the type of machine and the serial number, if applicable, is the precondition in order to
assert liability or warranty claims. If the original proof of purchase is not presented, we are
not able to perform any services.
 Defects resulting from the following circumstances are excluded from liability and warranty
claims:
the following circumstances occurred:
- Using the product beyond the technical options and proper use, in particular due to over-
Term Explanation
Cross table Bearing surface, clamping surface for the workpiece with X- and Y-axis
travel
Taper mandrel Cone of the drill or of the drill chuck
Workpiece piece to be milled, drilled or machined.
Draw-in rod Threaded rod to fix the taper mandrel in the spindle sleeve.
Drill chuck Drill bit chuck
Collet chuck Holder for end mill
Drill-Mill head Upper part of the milling machine
Spindle sleeve Hollow shaft in which the milling spindle turns.
Milling spindle Shaft activated by the motor
Drilling table Supporting surface, clamping surface
Taper mandrel Cone of the drill or of the drill chuck
Spindle sleeve lever Manual operation for the drill feed
Quick action -
Drill chuck
Drill chuck can be fixed by hand.
Tool Milling cutter, drill bit, etc.