Optimum Optimill MT 50 - Default Chapter; Table of Contents

To Next Page

To Previous Page

Version 1.2.8 - 2020-08-03 2 Translation of original instruction

MT50

MT50_GBIVZ.fm

Table of contents

1 Safety

1.1 Rating plate.................................................................................................................................................... 6

1.2 Safety instructions (warning notes)................................................................................................................ 7

1.2.1 Classification of hazards .................................................................................................................. 8

1.2.2 Other pictograms.............................................................................................................................. 8

1.3 Intended use.................................................................................................................................................. 8

1.4 Reasonably foreseeable misuses.................................................................................................................. 9

1.4.1 Avoiding misuses ............................................................................................................................. 9

1.5 Possible dangers caused by the milling-machine........................................................................................ 10

1.6 Qualification of personnel ............................................................................................................................ 11

1.6.1 Target group................................................................................................................................... 11

1.6.2 Authorized personnel ..................................................................................................................... 11

1.6.3 Obligations of the operating company............................................................................................ 12

1.6.4 Obligations of the operator............................................................................................................. 12

1.6.5 Additional requirements regarding the qualification ....................................................................... 12

1.7 Operator positions ....................................................................................................................................... 12

1.8 Safety measures during operation............................................................................................................... 12

1.9 Safety devices ............................................................................................................................................. 13

1.9.1 Lockable main switch..................................................................................................................... 14

1.9.2 Emergency-stop push button ......................................................................................................... 14

1.9.3 Milling table .................................................................................................................................... 14

1.10 Safety check ................................................................................................................................................ 15

1.11 Personnel protective equipment .................................................................................................................. 16

1.12 Safety during operation................................................................................................................................ 16

1.13 Safety during maintenance.......................................................................................................................... 16

1.13.1 Switching-off and securing the milling-machine............................................................................. 17

1.13.2 Using lifting equipment................................................................................................................... 17

1.13.3 Mechanical maintenance work....................................................................................................... 17

1.14 Accident report............................................................................................................................................. 17

1.15 Electrical system.......................................................................................................................................... 18

1.16 Inspection deadlines.................................................................................................................................... 18

2 Technical data

2.1 Electrical connection.................................................................................................................................... 19

2.2 Dimensions.................................................................................................................................................. 19

2.3 Adjustment travels/ Slewing ranges/ Distances........................................................................................... 19

2.4 Speeds / feeds............................................................................................................................................. 20

2.5 Drilling capacity............................................................................................................................................ 20

2.6 Coolant lubricant system ............................................................................................................................. 20

2.7 Operating material ....................................................................................................................................... 20

2.8 Environmental conditions............................................................................................................................. 20

2.9 Emissions .................................................................................................................................................... 21

2.10 Installation plan............................................................................................................................................ 22

3 Delivery, interdepartmental transport, assembly and commissioning

3.1 Notes on transport, installation, commissioning .......................................................................................... 23

3.1.1 General risks during internal transport........................................................................................... 23

4 Assembly

4.1 Unpacking the machine ............................................................................................................................... 24

4.2 Scope of delivery ......................................................................................................................................... 24

4.3 Installation and assembly ............................................................................................................................ 24

4.3.1 Requirements to the installation site .............................................................................................. 24

4.3.2 Load attachment points.................................................................................................................. 25

4.3.3 Installation...................................................................................................................................... 26

4.3.4 Cleaning and lubricating................................................................................................................. 26

4.3.5 Assembly of the chip tray............................................................................................................... 26

4.3.6 Functional test................................................................................................................................ 27

4.3.7 Check the filling level of the gear oil............................................................................................... 27