Version 1.2.8 - 2020-08-0326 Translation of original operating manual
MT50
GB
MT50_GB_3.fm
4.3.3 Installation
The milling-machine is fixed to the floor by four anchor screws which are past through the
machine foot. Optionally, 4 vibration damping elements can be used.
4.3.4 Cleaning and lubricating
Remove the anti-corrosive agents on the milling machine which had been applied for trans-
portation and storage. Therefore, we recommend you to use paraffin.
Do not use any solvents, cellulose thinner or any other cleaning agents which might affect
the coating of the milling-machine when cleaning the machine. Observe the indications and
notes of the manufacturer for cleaning agents.
Oil all blank machine parts using an acid-free lubricating oil.
4.3.5 Assembly of the chip tray
If it is not yet pre-assembled, assemble the chip tray using the fixing materials include in the
scope of delivery.
To Next Page
Loading...
