Optimum Optimill MT 50 - Operation; Safety; Control and Indicating Elements

Version 1.2.8 - 2020-08-03 29Translation of original operating manual
MT50 GB
MT50_GB_4.fm
5 Operation
5.1 Safety
Commission the milling-machine only under the following conditions:
 The milling-machine is in proper working order.
 The milling-machine is used as intended.
 The operating manual is followed.
 All safety devices are installed and activated.
All failures should be eliminated immediately. Stop the milling-machine immediately in the event
of any abnormality in operation and make sure it cannot be started up accidentally or without
authorisation.
Notify the person responsable immediately of any modification.
 Safety during operation on page 16
5.2 Control and indicating elements
Img.5-1: MT50
Control panel
with DPA2000
Machine illumination
Chip and splash guard
Crank handle
Table movement Y axis
Crank handle
Table height adjustment
Z axis
Vertical milling
Panel spindle gear
Star grip for spindle sleeve
feed
Fine adjustment of spindle
sleeve
Clamping lever for spindle
sleeve
Activation of the fine adjust-
ment
Moving the spindle head-
holder (forward or back)
Horizontal spindle
Crank handle
Table movement X axis
Panel feed gear
Gear lever
Feed speed Gear lever
Rapid / STOP / Feed