16 Sun SPARC Enterprise T5140 and T5240 Servers Installation Guide • December 2010
■ The front, middle, and rear sections form the slide rail. The middle and rear sections
have holes for mounting screws, and adjust to fit rack depths from 24 in. (61 cm)
to 36.5 in. (93 cm). The front section can be extended to allow movement of the
server out of the rack.
■ The removable mounting bracket slides 14 in. (35.5 cm) out of the slide rail, then
locks in place. If you unlock the mounting bracket at this point, it slides an
additional 12 in. (30 cm) before separating from the slide rail. You can then mount
the mounting bracket to the right or left side of the server chassis.
■ There are a total of five locks in a slide rail assembly. Four are on the mounting
bracket. One lock is on the front section of the slide rail. “Installing the Servers in
a Rack” on page 19 describes the uses of these locks.
To Next Page
Loading...
Need help?
General