42 Sun SPARC Enterprise T5140 and T5240 Servers Installation Guide • December 2010
ILOM System Console
When you power on the system, the boot process begins under the control of the
Integrated Lights Out Manager (ILOM) system console. The system console displays
status and error messages generated by firmware-based tests during system startup.
Note – To see these status and error messages, connect a terminal or terminal
emulator to the serial management port (SER MGT). For a basic procedure to connect
a terminal or terminal emulator, see “Power On the System for the First Time” on
page 43.
For a more detailed discussion on configuring the system console and connecting
terminals, refer to the Sun SPARC Enterprise T5140 and T5240 Servers Administration
Guide.
Related Information
■ “ILOM Service Processor” on page 42
■ Sun SPARC Enterprise T5140 and T5240 Servers Administration Guide
ILOM Service Processor
After the system console finishes its low-level system diagnostics, the ILOM service
processor initializes and runs a higher level of diagnostics. When you access the
ILOM service processor using a device connected to the serial management port, you
see the output of the ILOM diagnostics.
By default, the service processor configures the network management port
automatically, retrieving network configuration settings using the Dynamic Host
Configuration Protocol (DHCP) and allowing connections using Secure Shell (SSH).
Note – If you are unable to use DHCP on your network, you must connect to the
ILOM service processor using the serial management port to configure the network
management port for your network.
Related Information
■ “Power On the System for the First Time” on page 43
■ “Configure the Service Processor Network Management Port” on page 50
To Next Page
Loading...
Need help?
General