50 Sun SPARC Enterprise T5140 and T5240 Servers Installation Guide • December 2010
Note – After the root password has been set, on subsequent reboots, the ILOM CLI
login prompt is displayed.
2. Enter root for the login name followed by your password.
Related Information
■ Sun SPARC Enterprise T5140 and T5240 Servers Administration Guide
▼ Configure the Service Processor Network
Management Port
Note – If your network allows the use of DHCP, this configuration is performed
automatically the first time you boot the system.
Use this procedure only when:
■ You are unable to use DHCP on your network.
■ You need to modify the ILOM service processor network management port
settings.
-> set /SP/users/root password
Enter new password: ********
Enter new password again: ********
->
...
hostname login: root
Password: password (nothing displayed)
Waiting for daemons to initialize...
Daemons ready
Integrated Lights Out Manager
Version 3.0.0.0
Copyright 2009 Sun Microsystems, Inc. All rights reserved.
Use is subject to license terms.
->
To Next Page
Loading...
Need help?
General