88 Sun SPARC Enterprise T5140 and T5240 Servers Installation Guide • December 2010
FIGURE: Opening the Cage Clamp Using a Screwdriver
6. Feed the exposed section of the appropriate wire into the round hole in the DC
input plug.
FIGURE: Connector Wiring Assignments
Note – If you need to remove a wire from the DC input plug, insert the cage clamp
operating lever or a small screwdriver as and pull the wire from the DC input plug.
7. Release the lever or remove the tool to secure the wire into the connector.
Figure Legend
1 Top of connector 3 From chassis ground (green/yellow)
2 From -48V or -60V Return 4 From -48V or -60V
To Next Page
Loading...
