Note:
Active Directory has two modes: domain and workgroup mode, which
dictate how SMB users are authenticated. In domain mode, SMB clients
are authenticated through the Active Directory domain controller, and
you must ensure that the times on the appliance and the domain
controller match within five minutes. NIS is an older directory protocol
that is not very secure, and largely replaced by LDAP. It is not
recommended to run NIS and LDAP at the same time because they use
the same domain name setting.
Configure Name Services. Configure directory services for users and groups.
You
can configure and enable each directory service independently, and you can
configure more than one directory service.
Subcommands that are valid in this context:
nis => Configure NIS
ldap => Configure LDAP
ad => Configure Active Directory
help [topic] => Get context-sensitive help. If [topic] is
specified,
it must be one of "builtins", "commands",
"general",
"help" or "script".
show => Show information pertinent to the current context
abort => Abort this task (potentially resulting in a
misconfigured system)
done => Finish operating on "directory"
hostname:maintenance system setup directory> nis
hostname:maintenance system setup directory nis> show
Properties:
<status> = online
domain = sun.com
broadcast = true
ypservers =
hostname:maintenance system setup directory nis> set domain=fishworks
domain = fishworks (uncommitted)
hostname:maintenance system setup directory nis> commit
hostname:maintenance system setup directory nis> done
hostname:maintenance system setup directory> done
aksh: done with "directory", advancing configuration to "support" ...
6. Configure storage pools.
For detailed information, see Configuring Storage in Oracle ZFS Storage
Appliance Administration Guide, Release OS8.8.x.
Chapter 13
Performing Initial Configuration (CLI)
13-20
To Next Page
Loading...
Need help?
General
