Powering On the Appliance
This section contains power-on procedures for Oracle ZFS Storage Appliance disk shelves and
storage controllers.
Caution - Do not power on disk shelves and controllers until all other cabling is complete, as
described in “Cabling the Appliance” on page 115.
Follow these steps to power on the appliance:
1. Power on disk shelves using the appropriate procedure:
■
“How to Power On a DE2-24 Disk Shelf” on page 119
■
“How to Power On a Sun Disk Shelf” on page 120
2. Power on controllers. See “How to Power On a Controller” on page 121.
Use the following procedures to power off the appliance:
■
“How to Power Off a Disk Shelf” on page 121
■
“How to Power Off a Controller” on page 122
How to Power On a DE2-24 Disk Shelf
Use the following procedure to power on a DE2-24C or DE2-24P disk shelf.
Before You Begin
Ensure you have met the following electrical safety measures before applying power to the disk
shelf:
■
Provide a suitable power source with electrical overload protection to meet the power
supply input voltage range of 100-240 VAC, 50-60 Hz. The disk shelves are compatible
with 100-120 VAC or 200-240 VAC sources. The power source must not be overloaded by
the total number of disk shelves in the cabinet. At full load, each DE2-24 draws 707.8W.
■
The power source must provide a reliable earth connection for each disk shelf and the
cabinet.
■
Ensure that the power source is easily accessible because the power cord is the main
disconnect device for the disk shelf.
Powering On the Appliance 119
To Next Page
Loading...
Need help?
General