How to Power On a Sun Disk Shelf
1.
Plug a power cord into each power supply with fan module.
2.
Plug the other end of the power cords into the external power source for the
cabinet.
Note - To guarantee redundancy, power cords must be connected to two separate and
independent power sources.
3.
Supply power to the external power source.
4.
Place the power supply on/off switches to the "I" on position.
5.
Turn on the cabinet circuit breakers, if applicable.
6.
After the disk shelf powers on, which could take several minutes, ensure that
the system power indicator on the front of the disk shelf is lit a steady green,
and that each power supply with fan module status indicator on the rear is lit a
steady green.
If not, reseat the faulted module after powering off the disk shelf as described in “How to Power
Off a Disk Shelf” on page 121. If the module status indicator is not a steady green after
module reinsertion and powering on, contact Oracle Customer Service.
How to Power On a Sun Disk Shelf
Use the following procedure to power on a Sun Disk Shelf.
120 Oracle ZFS Storage Appliance Installation Guide • February 2016
To Next Page
Loading...
Need help?
General