How to Power On a Controller
Before You Begin
Ensure you have met the following electrical safety measures before applying power to the disk
shelf:
■
Provide a suitable power source with electrical overload protection to meet the power
supply input voltage range of 100-240 VAC, 50-60 Hz. The disk shelves are compatible
with 100-120 VAC or 200-240 VAC sources. The power source must not be overloaded
by the total number of disk shelves in the cabinet. At full load, each Sun Disk Shelf draws
912W.
■
The power source must provide a reliable earth connection for each disk shelf and the
cabinet.
■
The power source must be easily accessible because the power cord is the main disconnect
device for the disk shelf.
1.
Plug the two power cords into the universal power connectors.
2.
Connect the cords to the external power source.
3.
Turn on the disk shelf power switches.
4.
Wait several minutes until the power indicators are lit a steady green.
How to Power On a Controller
Use the following procedure to power on an Oracle ZFS Storage Appliance controller.
1.
Plug power cables into power supply 0 and power supply 1 on the storage
controller(s).
2.
Connect cables to the external power source.
3.
Wait until the Power/OK LED on the front panel next to the Power button lights
and remains lit (approximately two minutes).
If the Service Required amber indicator is lit, see Using Oracle ILOM to Diagnose Hardware
Faults in Oracle ZFS Storage Appliance Customer Service Manual. Also see the Oracle ILOM
documentation located in the documentation library for this software release at http://www.
oracle.com/goto/zfsstorage/docs.
How to Power Off a Disk Shelf
Use the following procedure to power off a disk shelf.
Powering On the Appliance 121
To Next Page
Loading...
Need help?
General