Orbisphere 3600 series - Default Chapter; Table of Contents

To Next Page

To Previous Page

3600 Analyzer for O

Measurement—Operator’s Manual 3

3600O2.OM.E9903

Table of contents

1. Operating Instructions ................................................................................. 5

1.1 What you have received........................................................................................5

1.2 What to check before using the system................................................................6

1.3 Instrument Operation...........................................................................................8

1.3.1 Program Flow Charts......................................................................................................9

1.3.2 Oxygen Measurement ...................................................................................................10

1.3.2.1 Warning Messages.....................................................................................................................11

1.3.3 Calibration Menus .........................................................................................................12

1.3.3.1 Instrument Barometric Pressure Calibration..........................................................................12

1.3.3.2 Oxygen Sensor Calibration in Air.............................................................................................12

1.3.3.3 Oxygen Sensor Direct Calibration...........................................................................................14

1.3.3.4 Model 28117 External Pressure Sensor Calibration...............................................................14

1.3.3.5 Model 32646.E Hydrogen Compensation for Oxygen Sensor..............................................16

1.4 Modify Options Menus ........................................................................................17

1.4.1 Display Units.................................................................................................................18

1.4.2 Thermal Cutoff..............................................................................................................20

1.4.3 Alarm Outputs...............................................................................................................20

1.4.3.1 Alarms Description...................................................................................................................21

1.4.4 Analog Outputs..............................................................................................................21

1.4.4.1 Analog Outputs Description.....................................................................................................22

1.4.5 Serial Output.................................................................................................................24

1.4.6 Salinity and Chlorinity Adjustments................................................................................24

1.4.7 H

Compensation Option (Model 32646.E)...................................................................25

1.4.8 Self Diagnostics .............................................................................................................25

1.4.9 Rolling Average..............................................................................................................26

1.4.10 Gas to Measure, CO

S Insensitivity.........................................................................26

1.4.11 Membrane Selection....................................................................................................27

1.5 Maintenance (Sensor Service)............................................................................28

1.5.1 When to Perform a Sensor Service................................................................................28

1.5.2 Remove Sensor from Sample.........................................................................................28

1.5.3 Prepare Sensor for Cleaning..........................................................................................28

1.5.4 Electrochemical Cleaning...............................................................................................29

1.5.5 Chemical Cleaning.........................................................................................................29

1.5.5.1 Ammonia Cleaning....................................................................................................................30

1.5.5.2 Nitric acid Cleaning...................................................................................................................30

1.5.6 Polish Sensor Face.........................................................................................................30

1.5.7 Replace Membrane........................................................................................................31

1.5.8 Put Sensor Back into Service..........................................................................................32

1.5.9 Shutting Down the System.............................................................................................32

1.5.10 Troubleshooting..........................................................................................................33

1.6 Spare Parts.........................................................................................................34

1.6.1 Oxygen Sensor and Protection Cap Diagram.................................................................35

1.7 Data Acquisition Software..................................................................................37

1.7.1 Program Setup ..............................................................................................................37

1.7.1.1 Windows 3.1 Setup...................................................................................................................37

1.7.1.2 Windows 95 Setup....................................................................................................................37

1.7.2 Menu Overview.............................................................................................................38

1.7.3 Configuring the Program ...............................................................................................38

1.7.4 Acquiring Data...............................................................................................................39

1.7.5 Printing, Copying, and Saving Data.................................................................................40

1.8 Warranty Information.........................................................................................41

1.8.1 About this Manual..........................................................................................................41

Main Page