38 3600 Analyzer for O
2
Measurement—Operator’s Manual
3600O2.OM.E9903
(Note: You can change the folder name at any time by clicking on the folder icon
with the right mouse button, selecting the Rename command, and then
retyping the name.)
4. In the Folders list, click on the Floppy (A:) drive icon.
5. Using the left mouse button, click on the Moca3600.exe icon and drag it to the
Moca3600 folder just created above, and then release the button. The
moca3600 program is now copied onto your hard drive.
Next, set up the moca3600 program for conventional Windows 95 access (i.e.,
where you click on a Start menu entry to start the program), as follows.
1. In the Explorer’s Folders list, first click on the plus sign next to the Windows
folder, then click on the plus sign next to the Start Menu folder.
2. Locate and click on the new Moca3600 folder icon in the Folders list.
3. Using the right mouse button, click and drag the Moca3600.exe icon to the
Programs folder (under the Start Menu folder), and then release the button.
4. Click the Create Shortcut(s) Here command on the menu displayed. A
shortcut icon is created in the Programs folder.
5. Click on the Programs folder icon in the Folders list.
6. To change the name of the shortcut icon (e.g., to remove the name “Shortcut
to...”), use the right mouse button to click on the Shortcut icon, then click on
the Rename command.
7. Type in “Moca3600 Program” over the program name, and press ENTER.
To start the moca3600 program, just choose the Start, Programs menu and click on
the Moca3600 Program icon from the Programs list.
1.7.2 Menu Overview
The moca3600 program main menus appear as follows:
The “File” menu includes typical Windows file management and printing
functions.
The “Terminal” menu commences and ends the data acquisition process.
The “Export” menu permits the information to be copied to the Windows
Clipboard, for pasting into other Windows programs.
The “Configuration” menu lets you customize the program for your application’s
requirements.
1.7.3 Configuring the Program
With the instrument connected to your PC, and the sensor placed in a sample,
start the moca3600 program and configure it for your data acquisition needs.
First, make sure the program knows which “COM” port will be used by your PC
by choosing Communications from the Configuration menu. The following Serial
port configuration box appears:
To Next Page
Loading...